Subject: Proposed oil cooler location?
From: Rotary Engine
Date: 2/4/2006, 9:47 PM
To: AA-me



   Paul-

   The idea of a 13"x 13"x2" oil cooler is a non-starter.  After messing
   around with the radiator, there is no way a square oil cooler is going
   to fit anywhere.

   After playing with a variety of locations, I came upon this idea:

   http://supinski.net:8080/IMG_2424.JPG ,
   http://supinski.net:8080/IMG_2425.JPG

   This mocked-up core would be 7" x 19" and 2 1/2" thick.  Obviously it
   could be the common 3" thickness instead.  Since this cooler is fed by
   the oil pump, is there any risk of the air high-point at the top causing
   problems?  My guess is no - the core will fill from the bottom at pump
   pressure & drive out the air as it goes.  I wonder if the pump can raise
   an oil column that high?

   I like this design because it makes plumbing the air diffuser easy
   enough; can bring air in a straight shot from the starboard cheek.  It
   also doesn't block access to the plugs & igniters (much).  My plan would
   be to allow air to pass through the cooler & then make it's way out of
   the cowling with no additional ducting.  In my mind the warmed air
   blows
   on the batteries & helps keep them at a reasonable temp before finally
   exiting at the bottom of the cowl behind the radiator.

   Finally - it lets me use the mounting bolts already on the end housing
   of the engine to solidly secure the cooler.

   Reasons why this won't work?

   Mark Supinski

   This will work fine with the right ducting. Brackets are the least
   of your worries.
   The pump will have no problem. Where did you find a 7" by 19" cooler?
   A stock 2nd gen cooler would fit fine along side the rad.

   A 13 by 13 would fit at about a 45 degree angle (about 9 inches wide
   in that case) where you have this one or a bit further forward to clear
   the motor mount tube. Or forward  laid back at a 45 degree angle to
   clear the motor mount tube. There are lots of options because your
   firewall is so high and the alt fits on top of the engine freeing
   up a lot of space on the right side.

   Your installation is looking real good Mark.
   Don't forget the jam nuts on the rear motor mount strut.

   Paul Lamar ...No rotor no motor.


7x19 was my guess on the  size of the actual cooling area of the stock
unit.  I think it's 22" in overall length.

I thought about putting it next to the rad, but didn't want to introduce
any issues caused by different resistance to airflow of the oil cooler
vs. the rad in a commonly ducted install.  Just seemed to be asking for
trouble.

In any case - after fishing around for the last few days I can pick up a
used stock gen 2 cooler for about 1/5 the cost of a comparable Setrab or
Fluidyne.  Might as well give the stock unit a shot.

Mark Supinski


The stock is 5.5 inches wide 19 inch core lenth about 23 24 inches long OA.
You can put in a vertical partition to favor one side or the other.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.