Subject: Ian bell housings]
From: Rotary Engine
Date: 2/6/2006, 6:05 PM
To: AA-me





> The web site for dellow is
> http://www.dellowauto.com.au
>
> I will be paying Jeff (Geoff) Dellow a visit in the next few days, and
will
> report.
>
> Colin Smith
> Sydney
>
>
> Thanks Colin.
> If the price is right looks like a very viable solution to our needs.
>
> Paul Lamar ...No rotor no motor.

Colin,
Ask Geoff if he will do a special bellhousing like the photo attached and
ask about cost to produce them - I have the pattern, it's the grey one!
George (down under)

Have visited Jeff Dellow at Dellow Automotive. The only bell housing that
fits a rotary is about 200 deep and does not have a mating face of large
enough dimensions for the gearbox  to either sit on or mount from the
inside.

Castings are outsourced  the selection of foundry being based on cost at the
time. I feel that this lead is dead.

Colin Smith>

Have visited Jeff Dellow at Dellow Automotive. The only bell housing that
fits a rotary is about 200 deep and does not have a mating face of large
enough dimensions for the gearbox  to either sit on or mount from the
inside.

Castings are outsourced  the selection of foundry being based on cost at the
time. I feel that this lead is dead.

Colin Smith


Too bad. Thanks Colin. Looked to heavy anywhy. I'll price a new
die cast RX8 auto tx bell housing.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.