snips....
And then you will have the problem of weight as you will be
lucky to get the wall of a sand casting down to less than about
6 mm. The best we can do in here the states is about 3.6 mm.
If you have somebody that can do 3.6 mm I am all ears.
George investigated it up where he is (Brisbane) and it was about 5 mm
as I recall. With a 3.6 mm wall the pattern must be super accurate.
And even then a certain percentage of casting are scrap.
There is no beating a high pressure die casting as the wall is
typically 3 mm or less. the tooling on the other hand is
$100,000 US.
Paul Lamar ...No rotor no motor.
Paul,
to give you an idea I tossed the idea of making the side housings in
alloy past them
they estimated that each housing for prototyping would cost approx
AU$3000 each
for the one offs rather like the picture you had on you side with a
steel insert.
Provided I gave them the cast iron version to based them on.
So with some info I can run it past them and let you know.
Do you have a housing that's suits or works now?
Does a pattern exist at this time?
Do you have a design / picture with dimensions?
Do have a specification for the type and grade of alloy wanted or required?
With last 2 then, I believe that I can ask them for some idea of the cost.
Small batches is something they do.
It is one of the reasons why I called them in the first place.
The do very short runs quite often.
Regards David Gaze
If we are talking end housings and not bell housings.
The third gen end and center housings are the best to copy for our purposes.
1993 to 2003. No side intake ports required as p-ports are
simple to make and GREATLY simplify the end housings.
While we are at it we could go with quasi parallel cooling.
356 is usually used and heat treated to T6.
No patterns no drawings. Richard Sohn has patterns.
We have some cutaways to copy the water jacket.
Here are some pictures.
Paul Lamar ...No rotor no motor.
-------------------------
Paul,
Actually I was talking about the bell housing/s sorry , I'm not being
clear.
Prototyping,
The side housings I will look at later on. Prototyping side housings is
time
consuming and I don't have the time at the moment, maybe later on this
year or early next year for the side housings.
Off the bell housing, on the side housings they did not seem mind about
things like exhaust ports, they have done other car type specials such as
blocks, heads, intake manifolds etc, so water jacket and the like do not
appear to of any concern.
I have bought a few of those rotary renesis engine from Rupert, so
once the new year quietens down a bit, actually a lot at the moment
then I'll be able to look at the side housing senarios..
In the meantime lets deal with the bell housing.
Regards David Gaze
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.