Subject: Aluminum end housings.
From: Rotary Engine
Date: 2/7/2006, 10:12 AM
To: AA-me



alloy past them
they estimated that each housing for prototyping would cost approx
AU$3000 each
for the one offs rather like the picture you had on you side with a
steel insert.
Provided I gave them the cast iron version to based them on.
So with some info I can run it past them and let you know.

Do you have a housing that's suits or works now?
Does a pattern exist at this time?
Do you have a design / picture with dimensions?
Do have a specification for the type and grade of alloy wanted or
required?

With last 2 then, I believe that I can ask them for some idea of the
cost.
Small batches is something they do.
It is one of the reasons why I called them in the first place.
The do very short runs quite often.

Regards David Gaze

If we are talking end housings and not bell housings.
The third gen end and center housings are the best to copy for our
purposes.
1993 to 2003. No side intake ports required as p-ports are
simple to make and GREATLY simplify the end housings.
While we are at it we could go with quasi parallel cooling.
356 is usually used and heat treated to T6.
No patterns no drawings. Richard Sohn has patterns.
We have some cutaways to copy the water jacket.

Here are some pictures.

Paul Lamar ...No rotor no motor.


Does anyone have access to a research / animal CT scanner ??  ( AKA - CAT
scanner ) - we could get the data for a pattern by scanning the stock
plates and changing the passages a little..

-dave


-- 
Best Regards /Mit freundlichen Gruessen,
  dave ( at ) arb.net http://arb.net



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.