Do you have any idea what you are expecting to pay, there is a
company not far from me that does do castings, prototyping is
a bit dear having said that prototyping are one offs of course
but low volume small quantities are not too bad. What I will
need is an applicable design to find out what it might cost.
I don't know is that helps at all. They definitely do alloy
including aviation grade castings
Regards David Gaze
I think people would pay around $300 US.
What say you people? What would you pay for a bell housing
to fit Tracy's PSRU?
Since patterns can be up to $5000 US this is a hard target
for 10 or 12 bell housings.
And then you will have the problem of weight as you will be
lucky to get the wall of a sand casting down to less than about
6 mm. The best we can do in here the states is about 3.6 mm.
If you have somebody that can do 3.6 mm I am all ears.
George investigated it up where he is (Brisban) and it was about 5 mm
as I recall. With a 3.6 mm wall the pattern must be super accurate.
And even then a certain percentage of casting are scrap.
There is no beating a high pressure diecasting as the wall is
typically 3 mm or less. the tooling on the other hand is
$100,000 US.
Paul Lamar ...No rotor no motor.
Paul,
Totally accurate and I agree with your assertions. My
investigations into
die castings is that Taiwan will amortise the pattern casting if you
purchases 1,000 or more. I thought that was good of them!
George ( down under)
I don't understand the appeal of a bell housing. Tracy's plate is
simple, light weight, inexpensive and in hand. There fore I like it
better than a bell housing. I think of a cast bell housing as
something we can worry about when we have the other more immediate
problems, such as cooling and getting the p port to perform solved.
I don't hear any one claiming the engine will perform better or more
reliably with a bell housing. Jerry
Ugly, crude looking and home made looking. IMHO
Esthetics are important in every product. Perhaps Tracy
would sell twice as many if they were more cosmetic.
The rotary engine movement would be further along
with a better looking PSRU. Also it is not that light
weight. The Ross was about ten pounds lighter with
the same gears and a cast bell housing and looked
far more professionally designed.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.