From the book
* Vee's For Victory! by Daniel D. Witney. An extensive and
comprehensive
book on the history and engineering of the Allison V-1700
liquid
cooled aircraft engine. 8.5 by 11, hard bound, 470 pages.
$59.95.
Schiffer Military History. Atglen PA ISBN:0-7643-0561-1
Note: little has changed in the past 70 years.
Since nose up climb is the worse case Allison got it right
here with the pressure tank mounted at the nose.
Here is what I suggest at this point in time for our use.
Paul Lamar ...No rotor no motor.
Ops not quite the 3D I wanted. Here it is along with the
"Sniffle"
valve :)
"Those that fail to learn from history are doomed to repeat
it."
Somebody other than me but I don't remember who.
Paul Lamar ...No rotor no motor.
So am I to infer that the idea of having a P tank and an A tank is
no
longer necessary? I ask because the expansion & overflow tanks
are
the
last pieces I need to order before mounting and connecting all of
the
engine plumbing. What capacity are we looking for in the P tank
then?
I presume it is larger than the 2-tank scheme, in order to make
room for
excess capacity / air gap.
Mark Supinski
I think you can get along with just a pressure tank and a 30 psi
pressure
cap. The RX8 does (15 psi pressure cap). BTW your firewall is so
high
you don't have to worry about mounting on the front of the engine.
Mount
it as high as you can get it on the firewall.
--
Paul Lamar ...No rotor no motor.
Actually, I was liking the front of engine position. My firewall is
completely jammed with various things already, so the front position
(which is absolutely clear) was sounding good.
Mark Supinski
Go for it. Ed Klepeis can weld you up something that looks
like the RX8 version.
BTW you can point the overflow vent straight up through the cowling
and then just like a Model T or Model A Ford if you start making
steam you will know it in an instant :)
Paul Lamar ...No rotor no motor.
Paul,
The drawing shows the P can's return line going to what appears to be
the wp outlet. Unless I'm mistaken, it should be connected to the inlet
(lower) hose?
Mark S.
No that is the inlet line to the top of the P-can and it is coming from
the output
of the block. The restricted out line off the bottom of the P-can is
going to
the half way point in the rad. That will work but to me more
faithful to the RX8 plumping scheme that should go to the water
pump inlet side. I just did it that way to shorten the line.
Paul Lamar ...No rotor no motor.
Paul,
OK, I didn't see the line going from the bottom of the P tank to the
forward tank (half-way point) of the dual pass radiator. That brings up
another question though. If coolant is flowing from the P tank into the
upper radiator tank, then how does trapped air escape from the forward
tank of the radiator? My system uses a cross-flow radiator and has a
bleed circuit that flows out of the radiator tank (on return side) and
into the top of the P tank. From there the coolant is drawn out from
the bottom of the P tank into the inlet side of the wp, leaving the
trapped air in the P tank. I just don't see how trapped air can get out
of the upper radiator tank on your system.
Another question... Wouldn't the air and coolant be churned up into a
froth as it passes through the water pump so that it would make it
difficult to separate the air from the coolant? I guess it would
eventually make its way into the P tank, but is seems like it would
happen faster if drawn from a less turbulent area.
Mark S.
Good point run a 1/4 inch vent line from the front of the rad to
the P-can. Or just hope the bubbles go up the down pipe. They
probably will.
Well more than one person says the dissolved air will eventually
make its way out of pressurized coolant and make its way to the top of the
P-can. I am not so sure. You could put temporary transparent lines
in your system and see after performing some ground runs.
You could also drill and tap into the output of the water pump where it goes
into the block and feed that to the P-can. Probably the best of
all scenarios.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.