From the book
* Vee's For Victory! by Daniel D. Witney. An extensive and
comprehensive
book on the history and engineering of the Allison V-1700
liquid
cooled aircraft engine. 8.5 by 11, hard bound, 470 pages.
$59.95.
Schiffer Military History. Atglen PA ISBN:0-7643-0561-1
Note: little has changed in the past 70 years.
Since nose up climb is the worse case Allison got it right
here with the pressure tank mounted at the nose.
Here is what I suggest at this point in time for our use.
Paul Lamar ...No rotor no motor.
Ops not quite the 3D I wanted. Here it is along with the
"Sniffle"
valve :)
"Those that fail to learn from history are doomed to repeat
it."
Somebody other than me but I don't remember who.
Paul Lamar ...No rotor no motor.
So am I to infer that the idea of having a P tank and an A tank is
no
longer necessary? I ask because the expansion & overflow tanks are
the
last pieces I need to order before mounting and connecting all of
the
engine plumbing. What capacity are we looking for in the P tank
then?
I presume it is larger than the 2-tank scheme, in order to make
room for
excess capacity / air gap.
Mark Supinski
I think you can get along with just a pressure tank and a 30 psi
pressure
cap. The RX8 does (15 psi pressure cap). BTW your firewall is so
high
you don't have to worry about mounting on the front of the engine.
Mount
it as high as you can get it on the firewall.
--
Paul Lamar ...No rotor no motor.
Actually, I was liking the front of engine position. My firewall is
completely jammed with various things already, so the front position
(which is absolutely clear) was sounding good.
Mark Supinski
Go for it. Ed Klepeis can weld you up something that looks
like the RX8 version.
BTW you can point the overflow vent stright up through the cowling
and then just like a Model T or Model A Ford if you start making
steam you will know it in an instant :)
Paul Lamar ...No rotor no motor.
Paul,
The drawing shows the P can's return line going to what appears to be
the wp outlet. Unless I'm mistaken, it should be connected to the inlet
(lower) hose?
Mark S.
No that is the inlet line to the top of the P-can and it is coming from the output
of the block. The restricted out line off the bottom of the P-can is going to
the half way point in the rad. That will work but to me more
faithful to the RX8 plumping scheme that should go to the water
pump inlet side. I just did it that way to shorten the line.
Paul Lamar ...No rotor no motor.
Paul,
If you route the out going along the incoming it will tidy up the
pulley and engine mount area.
--
Blake C. Lewis
Hey cool. Did you use MS Paint to do that? :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.