Subject: P38 plumbing history
From: Rotary Engine
Date: 2/9/2006, 6:09 PM
To: AA-me



Paul,
The drawing shows the P can's return line going to what appears to be
the wp outlet.  Unless I'm mistaken, it should be connected to the inlet
(lower) hose?

Mark S.

No that is the inlet line to the top of the P-can and it is coming from
the output
of the block. The restricted out line off the bottom of the P-can is going
to
the half way point in the rad. That will work but to me more
faithful to the RX8 plumping scheme that should go to the water
pump inlet side. I just did it that way to shorten the line.

Paul Lamar ...No rotor no motor.



Paul,
I have been meaning to ask, why have you ran the return ( of the 2 pass rad)
to the centre and not to the outside corner ( of the radiator) - is this the
norm in a 2 pass?
I thought it might tend to heat the 2nd pass flow through the partition,
having it closer to the partition.
George (down under)

Yes it is. Makes the plumbing shorter and more direct.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.