Subject: 2 rotors or 3?
From: Rotary Engine
Date: 2/13/2006, 6:48 PM
To: AA-me




    ***Snip***

    My question for all of you is this:  Is it un-reasonable to expect to
    get 300 HP out of a turbocharged two rotor engine through 12,000' and
    still squeak out 250 HP at FL20 without pushing the engine beyond
    reasonable limits?  Reasonable to me is in the range of 60% to 80%
    power.

    I would consider the 2 rotor engine as long as I did not have to "Trick
    it out" too far, compromising reliability for ponies.

    Bst rgds,

       Scott Carroll

    Lakeside, Ca.


Scott, I also suggest a 3-rotor.  While 300h.p. is possible from a
2-rotor, it would truly take a race quality team to be able to do it
without risk of detonation and overheating.   You are now getting into
the area of 3mm seals, cooling passage modifications, sophisticated fuel
delivery and dyno testing.  Turbo selection and installation will also
be critical.  There is no question that engine longevity will be down.
Rebuilds are relatively cheap and easy, but still a hassle.

Unless you are building a small Reno racer of some sort, stick with the
3-rotor.

Is 300 hp possible from a NA 20b?  The number I have most often seen is
a reliable 260 hp or so.

Jeremy S.  Velocity XL wings and fuse,
20b collecting dust in the corner

You need to street port it to get 300 HP and use a 2.85:1 gear box
so it can rev higher.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.