Scott Gettings wrote:
     > Attached is a pic of the stock Renesis main fuel rail.
     >
     > Its lines both attach near the center, and it has a device that
     > appears to be a pressure damper.  It is relatively heavy, and
     > really should be converted to AN fittings instead of the stock
     > plumbing.

    Mark Sipe replied:
     > Yes, it's a pulsation damper.  The RX-8 uses a single non-returning
     > line fuel system with the pressure regulator located in the fuel
     > tank with the pump.

    If the RX-8 indeed uses a non-returning line fuel system (and I'm *not*
    claiming otherwise), then what's the second fitting on the fuel rail
    for?

    Russell Kent


That's the main fuel rail.  The system feeds it and then on to a another
fuel rail.

I'm attaching a picture of the fuel system layout, not sure if it will
go through or not as some previous attempts did not appear to.

Mark Sipe




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.