Subject: Take off and cruise RPM.
From: Rotary Engine
Date: 2/13/2006, 7:27 AM
To: AA-me



    >
    >Thanks, Perry. What is your cruise RPM? I run 6000 to 6200 at
   cruise and
    >around 5700 at takeoff. Performance Prop 67" dia, unsure of pitch, I
    >think 68 or 70". Probably only making about 50 HP on one rotor, the
    >vibration from unbalance seems to soak up a lot of HP. I was
   descending
    >about 100-200 FPM at 4300
    >Chuck
    >
    >5700 at the start of the take off run Chuck? Static RPM?
    >
    >Paul Lamar ...No rotor no motor.


   I too cruise around 6000-6200. Max at WOT is 6400. When I takeoff
   it's only around 5200 RPM when I
   break ground at 80 knots. Climbing out at 100 knots it goes up to
   around 5400. 62" diameter narrow
   chord 3-blade and 68" pitch.

   Perry

   Perry's gear box is a 2.17:1. Numbers are higher with a 2.85:1


This all begs an interesting question -- what is the practical max RPM
we are looking at with the 13B Rotary?  At 2700 rpm (comparable to a
Lycoming) with the 2.85:1 redrive, I am looking at 7695 RPM on the
engine.  I believe this is greater than the suggested max from a couple
of days ago.  Based on the RPM discussions over the past few days, I am
wondering whether the 2.85:1 was a bad choice.

Mark Supinski

No it is not Mark. The 2.85:1 is a good choice. Ken Welter runs
3:1 and he is building a 3.2 to one as I recall. Power is directly
proportional to RPM in a free breathing rotary.

The guys seeing 7500 RPM on take off are those with a variable
pitch Hoffman or MT props. You will be lucky to get 6000 on take
off. I think Tracy sees 7300 on the top end with a 2.85:1 and a fixed
pitch prop.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.