I want to make the runners that go from the intake plenum to the
throttle body. This requires a 180 degree sweep. Can anyone tell me
how to approach such a project. Or recommend a good book on the
subject. Jerry
Jerry,
Probably the easiest way is to use carbon fiber sleeves. They are
seamless, sort of like the upper part of the sock, by stretching them
tone can reduce diameter and get tight fit over the mandrel. I used
them many times and they incredibly simlify making tubes. Also, they
make a neat final product. They are occasionally on ebay for good
prices, but I did not see any now.
See for example
http://www.sollerpaddles.com/composites/carbon%20fiber%20sleeves.html
Jerzy
Jerry, I tried this one time and will probably work more on it later.
Any way here's what I tried.
I then went to our local plastic supply house and purchased 2" ID.
clear acrylic tubing. You can heat the tubing to form what ever shape
you need, IE 180, 90 270 what ever, You have to be diligent and
careful but you can make pretty tight bends without kinking the acrylic.
Once you have your final shape cut the acrylic tube in half so you can
split it apart length wise. Coat the inside of the tube with silicon or
mold release. Then I took a 2.25" bicycle inner tube coated the out
side of the tube with silicon spray for mold release. I've never tried
the Carbon sleeve but it may work just fine for the next steps. I took
S glass and epoxy cut to size length wise add a little length. The
width should be pie times the Diameter so 3.1415 X 2" = 6.2813" times
the number of wraps. I used three wraps so 18.85" long.
Lay the
material on wax paper, pour the resin on the material, cover with
plastic wrap (like the stuff you use to cover a bowl for the
refrigerator). Use a rod to roll over the plastic wrap to distribute
the resin and push out any excess. peel the plastic wrap off and wrap it
around the partially inflated tube. Lay the whole mess into your acrylic
mold. Place the top half on and use heavy rubber bands or hose clamps to
keep it together. Then inflate the tube so you have the material
pushing against the inside of the acrylic mold. Let the whole thing
cure and split it apart. clean up the end and viola you now have a
light weight complex intake manifold. Like I said I think this process
has some merit and I'll work more on it later. T.W.
------------------------------------------------------
Here is a variation. Use the acrylic tube halfs as a mold to pour
the soluable plaster in.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.