Subject: Autoclave environment: was water soluable plaster
From: Rotary Engine
Date: 2/15/2006, 9:34 PM
To: AA-me



    > What are the temps. and duration in the autoclave? I am assuming
   it is a
    > vacuums inside.
    >
    > Thanks
    >
    > Doug Fir.
    >
    > Doug,
    > In an autoclave the norm is pressurized environment. The tool being
    > used has a vacuum bag and is pumped out through a bulkhead fitting.
    > Bill Jepson
    >

   Thanks Bill,
   Learn something new everyday:)

   Doug in Japan

Glad to help with your education. I forgot to include temperature
environment. Depending on the material to be cured, the temp varies. I
designed a small autoclave for the business I am a minor partner in. The
design is setup with multiple heating bands and a variable controller.

Most of the time we were curing vinylester resins. They set at about
180°F so we would set the controller to ramp to 190° dwell for about 10
minutes and then do a "flow temp" ramp to a cure temp as high as 375°.
The resin sets at 190 but will still allow the cure to de-bulk with a
high temp ramp. We end up with a very smooth part that is about 60%
fiber and 40% resin or less. All the materials are pre-preg, epoxy or
vinylester resin.

After removal and trimming the parts are post cured in
an oven to at least 350°f often for several hours. The resin systems can
be fiddly if you are looking for a good finish. The multiple steps
needed are one of the reasons carbon parts are so expensive. Oh another
thing; the reason that the autoclave is a pressurized environment is
that air is the heat transfer medium. In vacuum the only way to transfer
heat is by direct radiation, (read heat lamps), or conduction with a
heated form. Both of these methods are unreliable for mutiple parts or
very expensive. (the heated molds)
Bill Jepson


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.