Subject: How to make Carbon fibre tubes water soluble plaster]
From: Rotary Engine
Date: 2/16/2006, 7:51 AM
To: AA-me


Autoclaving is not for the weak at heart.  We use a lot of pressure and a
lot of heat.  Sometimes we even use argon because it has a better heat
coefficient than air and doesn't oxidize parts and tooling under pressure.

Vacuum bagging is sort of a poor middle ground between a wet layup and that
nasty autoclave.

eBay is an excellent resource for vacuum pumps (food sealers).   I purchased
one a couple of years ago on eBay for less than $20 including shipping and
after cleaning the dried veggies and funk off of it was able to draw
28.5inches of vacuum.  That is exactly what we got on our central ($$$$)
vacuum system here.

Do I need to tell you what happened, I mean happens, if you draw resin into
the kitchen pump?  A little resin trap is a good idea.  Again, mason jar
(cans collapse, oops I keep showing my mistakes) with a tube in and a tube
out.

Hobby Lobby is another good source for layup materials.  The polyester
quilting batting works exactly like the breather material you buy from a
composites supplier because it is exactly the same dang thing!

I'm still looking for a poor man's peel ply.  I think there is something at
the fabric store that works.  I just haven't found it yet.   The peel ply we
use is supposedly Teflon(tm) woven into a fabric.   It has to breath some
but won't stick to the resin.  It looks like lingerie material although, I'm
NO EXPERT on lingerie (whew!).

The shiny blue tape you see the pros use to seal to the tool is designed for
high temperatures.  Clear packaging tape from the hardware store works just
as well and is 10% the cost.

We have a room full of bagging films some of which I'll never use again
because they don't work.  The best stuff is nylon but it doesn't stretch so
we use it for flat layups, mostly.  For the kitchen layup use laundry bags,
painting drop cloth.

Now, here's a hot tip.  If you want to make a conformal bag, there is a
product out there that works like a charm.   It's called liquid latex and is
also available from Hobby Lobby as Castin' Craft Mold builder.  It's
designed to be painted, rolled or poured onto something you need to
replicate.  In it's shipped form it's a little heavy but it can be thinned
with a homemade solution of 50/50 ammonia and water.   Use distilled water
because if your tap water is a little hard you'll precipitate that out and
it will cause lumps (ask me how I know that.)

-Ben




Great info Ben. If you have a chance write this all up or just edit what
you have written and I will post it on the manifolds section of the web
site under your name of course.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.