Autoclaving is not for the weak at heart. We use a lot of
pressure
and a
lot of heat. Sometimes we even use argon because it has a better heat
coefficient than air and doesn't oxidize parts and tooling under
pressure.
Vacuum bagging is sort of a poor middle ground between a wet layup
and that
nasty autoclave.
eBay is an excellent resource for vacuum pumps (food sealers). I
purchased
one a couple of years ago on eBay for less than $20 including
shipping and
after cleaning the dried veggies and funk off of it was able to draw
28.5inches of vacuum. That is exactly what we got on our central
($$$$)
vacuum system here.
Do I need to tell you what happened, I mean happens, if you draw
resin into
the kitchen pump? A little resin trap is a good idea. Again,
mason
jar
(cans collapse, oops I keep showing my mistakes) with a tube in and
a tube
out.
Hobby Lobby is another good source for layup materials. The polyester
quilting batting works exactly like the breather material you buy
from a
composites supplier because it is exactly the same dang thing!
I'm still looking for a poor man's peel ply. I think there is
something at
the fabric store that works. I just haven't found it yet. The peel
ply we
use is supposedly Teflon(tm) woven into a fabric. It has to
breath
some
but won't stick to the resin. It looks like lingerie material
although, I'm
NO EXPERT on lingerie (whew!).
The shiny blue tape you see the pros use to seal to the tool is
designed for
high temperatures. Clear packaging tape from the hardware store
works just
as well and is 10% the cost.
We have a room full of bagging films some of which I'll never use
again
because they don't work. The best stuff is nylon but it doesn't
stretch so
we use it for flat layups, mostly. For the kitchen layup use laundry
bags,
painting drop cloth.
Now, here's a hot tip. If you want to make a conformal bag, there
is
a
product out there that works like a charm. It's called liquid latex
and is
also available from Hobby Lobby as Castin' Craft Mold builder. It's
designed to be painted, rolled or poured onto something you need to
replicate. In it's shipped form it's a little heavy but it can be
thinned
with a homemade solution of 50/50 ammonia and water. Use
distilled
water
because if your tap water is a little hard you'll precipitate that
out and
it will cause lumps (ask me how I know that.)
-Ben
Ben,
Dacron works as a peel ply. Drawback is it doesn't conform to shapes very
well.
Terry Adams
Thanks for that tip.
Expensive peel ply doesn't conform either.
Is that the grade that you cover aircraft with?
-Ben
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.