Subject: How to make Carbon fibre tubes water soluble plaster
From: Rotary Engine
Date: 2/17/2006, 12:16 PM
To: AA-me



    How were they molded and how were the inserts installed ?
    Kevin

I doubt they'll want to share that info since they do pretty good business
selling them to their fellow enthusiasts.  It all started off just like you
guys are doing; somebody with an idea in their garage.  As I said, just
showing these to fuel your thought process and end goal to shoot for.  The
only limit is your imagination, desire, and time. :-)

Here's a few more for an inline 6, this one differs from the previous one
with the CF plenum build around formed trumpets feeding from the main
chamber cavity.  I'm not sure what material the trumpets are made from.

TeamRX8




I'm guessing that they have permanent tooling for these parts given the
finish on the outside.  It looks like the CF was pushed into the tool with a
vacuum bag.

This is an excellent way to make parts and it yields very consistent
results.

The drawback, of course, is the cost of this kind of quality tooling.

I'll bet they are light as a feather, too.

-Ben



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.