Here's a few more for an inline 6, this one differs from the previous
one with the CF plenum build around formed trumpets feeding from
the main chamber cavity. I'm not sure what material the trumpets are
made from.
Boy, those trumpets shapes sure look wrong. They might want to read up
on Hoerner.
Right, Paul?
Russell Kent
Yes they do need to read Hoerner :)
When you cut them off at an angle like that they are not as bad as they look.
The white parts look like some sort of injected molded thermoplastic.
They look great from the outside as that as how they are sold.
I suspect that is why they are made like that.
As far as working well is concerned it is the inside that needs
to be slick. After all what is ten pounds on a 3500 pound car?
Are you willing to pay $500 to save 8 pounds on a street car?
In a case like that it is all cosmetics. Carbon is in.
Ben's technique focuses on the inside where it needs to be.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.