Subject: Paul Conner crash final FAA report
From: Rotary Engine
Date: 2/17/2006, 8:55 AM
To: AA-me


Don't know if anybody else noticed but the final FAA report on Paul's
[Conner] crash has been out since beginning of the month. According to the
report the likely cause of engine failure is the fuel valve selector
position which was partially sucking air from the empty right tank.
It
brings a memory flash of John Denver's death in his EZ with the fuel
selector problem.

So now I am glad to have a 2.3 gal sump tank where the fuel feeds
from
either tank with the selector valve. In fact I took off once with the
selector valve off and the sump tank low level warning light came on.
> richardt2005

Nothing about it being aft of the CG limit?  Amazing.
Paul, if the final report is out, can you now "talk"?

Perry Mick.

Sure! What do you want to know?

No way for me to know if the airplane was aft of the CG limit
or not. I am sure  he pulled too many G's (90 degree bank) and stalled
the canard trying to make it back to the runway. (There was a plowed field
more or less straight ahead.)

When that happens the canard airplane turns towards the ground.
That is what the pilot witness described. We had another fatal crash
similar situation at SZP when an air show pilot pulled too many G's
in a canard at low level and crashed in the river bed.

Paul got it rolled out 90 degrees and mostly pulled out but the
vertical velocity was still high when he struck the ground almost
level. Hard enough to bury the inflated tire below ground level.
It was not muddy ground either.

I felt it was the fuel selector valve but there is no real proof
as it could have moved during the crash. I will say the detentes
on that Andair fuel selector valve were no where near strong enough.

Some body else checked the only two fuel injectors well after the crash
and found one of them intermittent or some such. Not a good idea to use
only two injectors.

First mistake was taking off with an improperly designed fuel
system using a left, right and both fuel selector valve along with a
myriad of other errors in the fuel system design. Fuel in only one
tank.  Sump tank was like a 2 x 4 across the entire width of the
fuse. Sump tank was improperly vented to one strake tank. All
this is AFTER the crash.

Paul was not too good on sharing the details of his airplane with us.
For example we went around and around on the cooling.
When I got there and saw the airplane there were two large
holes one in each side of the plenum that was supposed to be
feeding air to the rad.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.