Doug,
Great news. I found a one man brand new NC machine shop right here
in Santa Paula that has agreed to make our prototypes.
I am building two and will ship you one no charge.
I am ordering all the off the shelf parts on
Monday. You will need an electric cooling pump.
The rollers are 38 mm wide instead of 30 as that is
just what the bearings came out to. Bearings went down to
a 5/8 bore (16 mm) but bearing speed went up to
30,000 RPM.
I am still refining the design so I will keep you informed.
I will supply the 3 inch poly v belt out put pulley
and a coupling to the 2nd gen stock turbo shaft.
You will have to build a bracket to mount it on your engine.
We get this working and I will go into production :)
20 % less fuel burn on your turbo rotary.
We can then start setting long distance flight records for
lightplanes. Good PR.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.
output pulley multi v groove
pitch dia. 3.03 inches ID 1.38" width 1 3/32 part # 1405K32 $47.42
10 grooves bushing size JA page 913
HP = tor x rpm/5151
50/12000 x 5151 = tor = 22 ft pounds = 258 inch pounds
5/8 shaft will take about 888 inch pounds
JA bushing page 898 5/8 bore 6066K11 $6.54
hardened and ground shaft 3/8 soft end 1144K19 $22.50 10 inches long page 925
-.0005 to -.001 8 to 12 micron Rc 60 to 65
hardened and ground shafts 5/8 for bearings 3" long 6061K434 $4.87 page 924 need 3
-.0005 to -.001
Bearings precision HJ 101812 Torrington bore .625 OD 1.125 30,000 RPM 3/4 inch wide
7929K21 $10.81 shaft +.0008 to +.0017 need six page 989
spacer screws 3/8 inch head dia .781 page 2897 2.25 inch long 52.35 per 100 need 3
part number 91253A633
thrust washer 1/16 58 shaft 1 3/16 part # 7814K23 page 973 $2.57 each need six