Subject: New NC mill coming on line for molds.]
From: Rotary Engine
Date: 2/18/2006, 8:54 PM
To: AA-me


Well I can no longer keep quiet on this issue.
:-)  I wasn't going to say anything about this
until I was perfectly ready, however due to the
many discussions along this line in the last
little while, I'll just mention it briefly.

Where're you gonna be located?  I live N. of Charlotte.
--Kent
Concord


Kent its going to be Located in Canada, I live
about 40 miles from the US Border [ almost
directly North of the Mt/Nd boarder.  Actually
Perry Cason [ whom I believe is on this list also]
fly's a 13B powered Glastar and is from my EAA
chapter.

Jarrett


Duh!.  I though "NC mill" meant "North Carolina mill".  Guess you
meant "Numerical Control".  ;-)
-Kent

North Carolina instead of Georgia must be on your mind :)

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.