On your four pump system you need to run your feed lines through the
selector valve too don't you ?
John
Yes but it is only single level valve and not a two level valve.
That gives one a much wider choice of valves. Not only that
the height of the valve mounting now becomes irrelevant.
The down side of that system also requires the pilot to do
two things and not one when switching tanks
making it slightly more pilot error prone. He must switch the
return fuel and select the correct pump electrical switch.
The fuel quantity gages are more important
in a low wing airplane as now one must get the vast majority of
the fuel out of one tank before switching to the tank with the most
fuel for landing.
As a back up system it would be nice if you
had a timer combined with a flow meter on each tank so you knew
how many gallons of fuel you burned out of each tank. You would
have to remember to reset them when the tanks were filled.
BTW there are a few more systems that will work also.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.
<four-pump-sys-3D.jpg>
Paul,
Is there a reason not to use an electric valve for the return line?
Since the pilot is electrically switching the pumps it would be fairly
easy to wire up a switch to handle pump and valve simultaneously.
Ken Bauman
No real reason other than something else to fail.
Also won't work if there is no juice :)
Paul Lamar ...No rotor no motor.
Probability of failure is probably lower than the probability of pilot
failure, especially if the pilot is unfamiliar with the a.c. (possibly less
so with an experimental as fewer people would fly an individual a.c.). Given
that one of the biggest killers in aviation is errors in fuel management it
seems odd that fuel systems were never standardized, at least to the point
where similarities were more common than differences. In one small fleet of
Beavers we had three different fuel selector valves that all looked the same
yet were operated differently. Small ergonomic things were managed, knobs,
levers and handles are somewhat standardized. Oh well I guess it is too late
now.
John
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.