Subject: self-lubricating end housing coatings
From: Rotary Engine
Date: 2/22/2006, 9:46 AM
To: AA-me

If you can believe anything Moller says :)
It is pretty easy to pull the wool over NASA's
eyes :)

Note: Moller did not mess around with the OMC rotor housing
tungsten carbide rotor housing coatings. Probably applied
with a detonation gun and diamond ground.

Down load from:
http://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/


Paul Lamar

Evaluation of thermal barrier and PS-200 self-lubricating coatings in an air-cooled
 rotary engine
Moller, Paul S.
NASA Center for AeroSpace Information (CASI)
NASA-CR-195445; E-9493; NAS 1.26:195445 , 19950301; Mar 1, 1995
This project provides an evaluation of the feasibility and desirability of applying
a thermal barrier coating overlaid with a wear coating on the internal surfaces of
the combustion area of rotary engines. Many experiments were conducted with different
combinations of coatings applied to engine components of aluminum, iron and titanium,
and the engines were run on a well-instrumented test stand. Significant improvements
in specific fuel consumption were achieved and the wear coating, PS-200, which was
invented at NASA's Lewis Research Center, held up well under severe test conditions.
Accession ID: 95N23222
Document ID: 19950016805
View PDF File
Updated/Added to NTRS: 2005-08-25


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.