I'm looking at fuel pumps, filters and a pressure regulator for my
Renesis installation.
The RX-7 systems look like they usually runs around 40-50 psi, with
maximum pressures 70-100 psi. The RX-8 computer regulates fuel rail
pressure according to demand.
The popular aftermarket pumps (Walbro et. al) are usually available in
190 lph or 255 lph, with both standard-pressure and high-pressure
versions. The latter offer a few gph more flow at the higher pressures.
Still, most of the fuel pump flow rates drop off dramatically at higher
pressures, such as 80 psi.
Is there a recommended fuel rail pressure and flow rate that will handle
the 6 injectors on the high-power version at full power?
What fuel filter screen size is best for these injectors? 10 to 100
microns seems to be the common range.
thanks!
Scott Gettings
Well at full power the BSFC can go as high as .65.
If you have 250 HP that is 162.5 pounds per hour or 27 gallons per hour.
Each of the six injectors must be capable of about 5 gallons an hour.
190 liters per hour (lph) is roughly 50 gallons an hour.
The RX8 fuel system pressure is 56.6 psi or (3.98 Kgf/cm^2) from the
service manual.
The better the filter the better.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.