Subject: Hose ends on stainless steel hose
From: Rotary Engine
Date: 2/27/2006, 1:39 PM
To: AA-me



Hello,

I almost feel kind of silly posting this, compared to the other things posted on
this discussion board, but...


I’m in the process of putting the hose ends on the stainless steel braid hose
for my oil system.  I’ve sheared off the nipple on the AN fitting on a smaller
hose while trying to screwing the two pieces together and I don’t want to make
the same mistake twice.  Can someone tell the correct way of doing this?

Thanks,

Burck

Use  a torque wrench and it is inch pounds and not foot pounds.

Blake Lewis


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.