Subject: Hose ends on stainless steel hose
From: Rotary Engine
Date: 2/27/2006, 8:08 PM
To: AA-me


>
> Hello,
>
> I almost feel kind of silly posting this, compared to the other
things posted
> on
> this discussion board, but...
>
>   I’m in the process of putting the hose ends on the stainless steel
braid
> hose
> for my oil system.  I’ve sheared off the nipple on the AN fitting
on a
> smaller
> hose while trying to screwing the two pieces together and I don’t
want to
> make
> the same mistake twice.  Can someone tell the correct way of doing
this?
>
> Thanks,
>
> Burck


> Use  a torque wrench and it is inch pounds and not foot pounds.
>
> Blake Lewis

I assume there are torque specs out there referring to hose ends -- if anyone
has them could you please post them.  Just to avoid any confusion out there, I'm
only talking about threading the "nipple" part of the hose end to the socket --
please refer to the picture at this link:
http://www.russellperformance.com/tech_center/manual_hose_ends.htm

Thanks,

Burck

I am not sure these torques apply to your problem. Got a digital camera?
You may also have the wrong hose for that fitting.
What brand of hose fitting is it? There are some look alike cheap
AN fittings out there made who knows where out of who knows what.
Perhaps not the right alloy or heat treat.


Paul Lamar ...No rotor no motor.


        Please use a Mandrel when fabricating the items. It will prevent
"skiving"
the center of the hose and causing problems, Virg



I make braided stainless hoses almost daily, for oil and brake systems.
While there are several styles of connectors, when tightening, never
bottom of the fittings out. Allow an approximation of at least one thread
space.
Another tool I use for assembly is the Koul Tool.
Even with some braid "frazzled" these tools make assembly a snap.
They are available in six popular sizes.
Archie



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.