Hello,
I almost feel kind of silly posting this, compared to the other
things posted
on
this discussion board, but...
I’m in the process of putting the hose ends on the stainless steel
braid
hose
for my oil system. I’ve sheared off the nipple on the AN fitting on a
smaller
hose while trying to screwing the two pieces together and I don’t
want to
make
the same mistake twice. Can someone tell the correct way of doing this?
Thanks,
Burck
Use a torque wrench and it is inch pounds and not foot pounds.
Blake Lewis
I assume there are torque specs out there referring to hose ends -- if
anyone
has them could you please post them. Just to avoid any confusion out
there, I'm
only talking about threading the "nipple" part of the hose end to the
socket --
please refer to the picture at this link:
http://www.russellperformance.com/tech_center/manual_hose_ends.htm
Thanks,
Burck
I am not sure these torques apply to your problem. Got a digital camera?
You may also have the wrong hose for that fitting.
What brand of hose fitting is it? There are some look alike cheap
AN fittings out there made who knows where out of who knows what.
Perhaps not the right alloy or heat treat.
Paul Lamar ...No rotor no motor.
try the instructions here:
http://www.stockcarproducts.com/aqp1a.htm
Kevin
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.