Subject: Hose ends on stainless steel hose
From: Rotary Engine
Date: 2/27/2006, 10:11 PM
To: AA-me




Hello,

I almost feel kind of silly posting this, compared to the other things posted on
this discussion board, but...


I’m in the process of putting the hose ends on the stainless steel braid hose
for my oil system.  I’ve sheared off the nipple on the AN fitting on a smaller
hose while trying to screwing the two pieces together and I don’t want to make
the same mistake twice.  Can someone tell the correct way of doing this?

Thanks,

Burck



Burck,
You must have a mandrel for the size hose you are assembling.  They are
easy to make, but $25 to $40 or more to buy....more about this later.
Here is the assembly process:

1)  Cut the hose off so the end is square to the length.  Use a fine
tooth hack saw, a hose cutter, or a thin abrasive cut-off wheel to cut
the braid.

2)  Clamp the socket lightly in a vise.  Screw the hose end into the
socket until it bottoms (threads may be left hand).  Back the hose out a
quarter turn (very important).  If  you can't apply enough torque to the
hose by hand, clamp the hose in the vise and turn the socket on with a
wrench.  Mark the hose at the edge of the socket with a wrap of tape or
a permanent marker so you will know if it backs out during the insertion
of the nipple.

3)  Insert the mandrel into the nipple and tighten it moderately with a
couple of wrenches.  Lubricate the nipple and mandrel with light machine
oil or hydraulic fluid.
4)  Position the hose and socket in the vise so you can thread the
nipple into the hose and socket with a continuous rotation.  It will get
warm to the touch.  I  usually use a socket wrench on the mandrel.

5)  When the mandrel bottoms against the socket, back the nipple out
with a wrench on the nipple (so the mandrel won't back out) to give a
clearance of about .030" between the nipple and the socket.

6)  Remove the mandrel and you are done.  The hose should be pressure
tested, but, I've never had one to leak.

You can make a mandrel from a straight AN816 fitting and a piece of
steel rod the diameter of the hose ID.  Flatten the rod somewhat near
one end so you can press it into the fitting.  Filling the fitting with
epoxy will help secure it.  The rod should be long enough that when the
fitting is screwed into the nipple above that it protrudes at least a
half inch into the hose as it is assembled.  Put the rod into a drill
press and round the end with a file.

Aubrey




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.