Subject: Hose ends on stainless steel hose
From: Rotary Engine
Date: 2/27/2006, 10:15 PM
To: AA-me




> >
> > Hello,
> >
> > I almost feel kind of silly posting this, compared to the other things
posted
> > on
> > this discussion board, but...
> >
> >
> > I’m in the process of putting the hose ends on the stainless steel
braid
> > hose
> > for my oil system.  I’ve sheared off the nipple on the AN fitting on a
> > smaller
> > hose while trying to screwing the two pieces together and I don’t want
to
> > make
> > the same mistake twice.  Can someone tell the correct way of doing
this?
> >
> > Thanks,
> >
> > Burck
>
>
> > Use  a torque wrench and it is inch pounds and not foot pounds.
> >
> > Blake Lewis
>
> I assume there are torque specs out there referring to hose ends -- if
anyone
> has them could you please post them.  Just to avoid any confusion out
there, I'm
> only talking about threading the "nipple" part of the hose end to the
socket --
> please refer to the picture at this link:
> http://www.russellperformance.com/tech_center/manual_hose_ends.htm
>
> Thanks,
>
> Burck


Burck,
Get a copy of the Earl's catalog.  They have assembly instructions for the
hose ends.  You must also use a feeler gauge.  Definitely blow your hose
assembly clean with compressed air after you have completed the hose and
ends.
If you would like I can email you the instructions.

Terry Adams


Send away Terry I'll add it to the archive.


The web link provided by Kevin has nearly the same instructions as the
Earl's catalog.
    http://www.stockcarproducts.com/aqp1a.htm
Earl's recommends a feeler gauge, but a thumbnail could also work.
The recommended mandrels are a help, but not necessary.

Terry Adams



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.