Subject: Major update to the web site
From: Rotary Engine
Date: 3/6/2006, 7:10 PM
To: AAme


Come to think of it, I have to wonder why Mazda has not explored
turbo compounding for the rotary. Like you said, this engine is a perfect
gas generator for spinning a turbine.

I would think though that in auto applications at the low power that is
typical of highway cruise, there is not that much exhaust energy. It
would have to be a pretty small turbine, but then you would run the risk
of over speeding it in full-throttle acceleration.
Gordon


You can't overspeed a turbine that is connected to your engine output
shaft with a belt.

Hans

Depends on the ratio Hans. At 20:1 over all we will have to limit engine
RPM to 6000. At 6000 engine RPM the turbo will be going 120,000 RPM.
That is fine for testing but I suspect the final drive ratio
will be more like 1.7:1 rather than 2:1 so given a 10:1 traction
drive 7000 engine RPM will give 119,000 turbo RPM.

With a three inch pulley on the traction drive that will allow use to
use a five inch pulley on the e-shaft. 1.666:1  One point six to one.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.