Come to think of it, I have to wonder why Mazda has not explored
turbo compounding for the rotary. Like you said, this engine is a
perfect
gas generator for spinning a turbine.
I would think though that in auto applications at the low power that
is
typical of highway cruise, there is not that much exhaust energy. It
would have to be a pretty small turbine, but then you would run the
risk
of over speeding it in full-throttle acceleration.
> Gordon
You can't overspeed a turbine that is connected to your engine output
shaft with a belt.
Hans
Depends on the ratio Hans. At 20:1 over all we will have to limit
engine
RPM to 6000. At 6000 engine RPM the turbo will be going 120,000 RPM.
That is fine for testing but I suspect the final drive ratio
will be more like 1.7:1 rather than 2:1 so given a 10:1 traction
drive 7000 engine RPM will give 119,000 turbo RPM.
With a three inch pulley on the traction drive that will allow use to
use a five inch pulley on the e-shaft. 1.666:1 One point six to one.
Paul Lamar
You can't overspeed a turbine that is connected to your engine output
shaft with a belt. (at an appropriate ratio)
Hans
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.