I did a major update to the web site reflecting the
recent break through in the efficiency of the internal combustion
engine.
Paul Lamar ...No rotor no motor.
Paul,
That's a very nice compendium of info on turbo compounding.
Just looking again at your most recent drawing of the proposed layout
using your new-design gearbox, I have to wonder again why you don't put
the box in the middle between the turbine and the compressor.
The sun shaft of the gearbox can be the common shaft on which the
turbine and compressor ride -- and it can pass right through that big
hollow tube on the planet carrier (on which the pulley sits.)
Then you can turn the whole thing right around so your intake mouth on
the compressor is facing into the airstream and the exhaust from the
turbine is facing aft.
Regards,
Gordon.
I think I see what you are up to. Interesting idea.
Keep in mind the sun shaft must be no larger
than 3/8 th while a typical turbo charger shaft can be as large as 1/2"
or 5/8th of an inch. There are whirl mode considerations as you have two
small flywheels separated by a small shaft of finite length. The
dynamics of turbo chargers is more complicated then it looks. Then
you have things like the torsional resonant frequency of the thin 3/8 shaft
with small flywheels on each end. Another issue is heat transfer from the
turbine to the gear box. It could be made to work with enough R&D but
I suspect the current set up with the shaft coming out of the air intake
to the compressor will be easier to get to work and the lessor evil. For
example it would be easy to introduce a low temp rubber coupling between
compressor and gear box if found necessary. Aerodynamically there is
little or no drawback as the compressor is an annular
intake device anyway. In other words air is taken in in a hollow
cylindrical shape.
The last advantage is this box can be attached to any stock off the shelf
turbo charger so R&D is simplified.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.