Subject: TurboCompond Tubine Rotor Burst Zone
From: Rotary Engine
Date: 3/6/2006, 11:51 AM
To: AACRE NL



   To Paul, Doug, et al,

   First of all I want to congratulate Paul and Doug for their persistent
   dedication to a very worthwhile goal:  Increasing the overall
   efficiency of
   the internal combustion engine.

   I am working for a company that is developing a new aircraft type design
   that uses turbine engines.  To certify this aircraft, the design must
   *minimize* the impact of a rotor burst from the turbine engine in
   regards to
   structure and flight control linkages etc.  I realize that the
   experimental
   category does *not* have to meet the FAA requirements regarding
   rotor burst,
   however, it may be very wise to consider minimizing the impact of a
   rotor
   burst from a safety point of view.  Do turbochargers ever have a
   rotor burst
   that can cause shrapnel to be ejected from the plane of
   rotation?  If so,
   could a larger turbo compound turbine have an increased potential?

   This may be something to think about when routing fuel, coolant, and oil
   lines for example.

   Norman DeBoer

   The stock turbine is made from sintered dust. When they die it is:
   Dust unto Dust :) Actually it is called sintered metal powder. I
   have seen
   three stock turbines fail so far. Probably all three from over speed.

   ------------------------

   I forgot I had a picture.

   Paul Lamar ...No rotor no motor.

Turbocharger housings are usually heavy cast iron, yes?  An adequate
scatter shield, I think.

The failures are a broken shaft, followed by bent blades, I think.


Matt-

The turbocharger weighs 21 pounds which is mostly high strength cast iron.
BTW The stock Mazda Turbo II  exhaust manifold is another 10.5 pounds.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.