Paul-

Trying to design the front mount for my rad.  The current thinking is to
use the 2 small bolts on each side of the SBeam as the mount points.  A
single piece of hollow round bar stock is bent through a variety of
angles to go from the bolts on one side, down to the rad front, welded
ears connect the bar to the rad, and then bent up to the bolts on the
other side.  At each end of the bar, it is crushed flat to allow hoes to
be drilled and the bolts to extend from the SBeam, through the crushed
ends, and then nuts to hold it all together.

Here are 2 fuzzy photos where I've tried to draw in what I'm talking about.


Thoughts?

Mark

I would make a K&L wedge shaped diffuser and bond or bolt it to the
rad. It needs to be perfectly sealed anyway. Then bolt the diffuser to
the bottom of the S beam or a strap around the S-beam using a few rubber
grommets to give a bit of vibration isolation. Make one part do two jobs.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.