I thought I would run this by you guys and see if somebody can come
up with a better idea. I have thought about it and thought about it
and did several other 3D prototypes using these one way clutchs. The
requirements for these things to work is the shaft must be located
with another bearing relative to the center line of the clutchs as
otherwise they don't work.
I used a simple ball bearing to do that job recessed into the back face
of the front half of the planet carrier. This bearing only
sees rotation when the clutches are not locked up. At other times
it only sees the difference in RPM between the planet carrier
and the output shaft. In general that will only be several thousand
RPM. Nothing for a small bearing of this 1/2 inch bore size.
Max RPM on this bearing is 28,000 RPM from the old catalog.
The other two bearings on the other end of the 3/4 inch shaft take
the considerable side load from the drive belt. Max RPM on those
is 19,200 in the old catalog and 11,300 in the new. Take you pick.
The clutches turned out to be a bit more complicated than they looked
at first glance.
Paul Lamar ...No rotor no motor.
Missing the drawing Paul.
Hans
Ops sorry. Here it is.
Been up since five working on this. Getting a bit dopey.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.