This is from:
www.gepower.com/prod_serv/products/tech_docs/en/downloads/ger3567h.pdf
Since the exhaust gas temperature of the Wankel is pushing
the limits of turbine inlet temperature this GE blade cooling
technique has some merit in extracting yet more HP from
the Wankel exhaust and further lowering the BSFC. The steam can
be fed into a small BMW style "expander"
(1750's era piston steam engine :)) and used to drive engine accessories
such as the alternator and water pump.
Paul Lamar ...No rotor no motor.
The theory is good paul, but these are stationary nozzles from a huge
stationary base load Power generation gas turbine.
You are using a turbo charger, and thus a scroll rather than stators. The
turbine is too small to do integral cooling. The heat flow and temp out of
the Wankel at our duty cycle is going to be a real challenge though. Has
anyone got a reliable turbocharger to work at our duty cycle?
Regards,
Mark
Yes. I was thinking about the difficulty of liquid cooling the turbine directly.
Probably better to use a heat exchanger to generate the steam just before
the turbine and cool the exhaust gas 200 F before it is applied to the turbine.
Yes. I am pretty sure what was happening was the HP capabilities of the stock
turbine was excessive enough to assure rapid acceleration of the turbo charger
so the turbine was failing from over speed at constant high power at around two
hours. The centrifugal load on the blades are enormous at 100,000 RPM and above.
Dave Leonard swapped out the stock compressor for a larger TO4 compressor slowing
the turbo charger and the problem appears to have gone away.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.