Does anyone have one of the special tools required to separate the
eShaft on the 20b.  I found one at Scalliwags.com but the site seems to
be down for ordering and there is no contact number.  I maight be able
to weld one up with 4130 tubing but it will take a little bit to mock it
up without the original dimensions.

If someone could lend me the tool I will pay the shipping both ways.  If
someone has a diagram of the tool, that will help as well.

Thanks,

Keith Stevens

Hi Keith, you don't need one.  All you need to do, after removing the front
iron
housing, front rotor housing, and front rotor, is to place the 1 1/4"
e-shaft bolt
back on, then "dink" it once with a hammer.  This should break the lobe free
from the keyway indexer, thereby allowing you to slide it off.

http://bdc.cyberosity.com/v/ProjectCars/ReeseLeBlanc/Removal_Teardown/?g2_page=3

Good luck,

B


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.