Subject: Future potential of the turbo compound Wankel
From: Rotary Engine
Date: 3/13/2006, 12:09 AM
To: AAme



This is from:

www.gepower.com/prod_serv/products/tech_docs/en/downloads/ger3567h.pdf

Since the exhaust gas temperature of the Wankel is pushing
the limits of turbine inlet temperature this GE blade cooling
technique has some merit in extracting yet more HP from
the Wankel exhaust and further lowering the BSFC. The steam can
be fed into a small BMW style "expander"
(1750's era piston steam engine :)) and used to drive engine accessories
such as the alternator and water pump.

Paul Lamar ...No rotor no motor.



Paul,
I think that the GE concept is applicable (been applied) to larger turbines
(i.e. jet engines). It would be a real manufacturing challenge to make the
internal flow passages in a turbine sized for a Mazda engine.

Bill Schertz
KIS Cruiser # 4045


Yes I agree. The solution is to insert the heat exchanger between exhaust port
and turbine to cool the exhaust gas 200 F before it enters the turbine.

Paul Lamar ...No rotor no motor.


Paul

Just misting in compressed air and water directly into the turbine might do
the trick. Remember that 2 amp. high speed 24vdc high pressure turbine I
showed you off of my fuel cell unit?  The outlet is a PT 1/2" id pipe
fitting.

Or just blowing air through an exhaust  manifold like Mistral designed might
lower the exhaust temp 200 degrees which should bring your turbine into an
environment that it could live with for a while. It will lower your
potential energy that you can recover but  so what. High rpms plus high heat
is a formula for blade creep.

To get the proper spacing it  looks like you are going to have to whip up
another manifold in any case.

Doug


The whole idea here is to capture that heat and put to work driving
the accessories with a small steam engine. Again doing two jobs
with one device.

I have enough spacing. If I need a bit more it is easier to
shorten the intake tube by 3/4 of an inch on the compressor and
machine a trumpet mouth on it.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.