Subject: Motor teardown results
From: Rotary Engine
Date: 3/15/2006, 11:02 PM
To: AAme

I finally got time to get my failed 13b apart. The rear rotor was
missing one apex seal, the other 2 were intact but jammed due to the
fragments of the broken one. The rotor housing has the classic chatter
marks all around. Doing a Google of "13B apex seal chatter" results in
plenty of examples of this failure mode. Apparently the chatter is from
the natural resonant frequency of the seal, it eventually fatigues the
seal causing failure.
The front rotor was in good shape, but the housing had the same chatter
marks, but not as severe as the rear rotor. The front rotor housing was
brand new 150 hours ago when I rebuilt this motor after the Grand Canyon
forced landing. At that time the good rotor housing had slight chatter
marks but I reused it. The front rotor was destroyed at that time due to
foreign object entering the rotor.
Both rotors were missing the  corner seal rubber plugs on the side with
the short apex seal segment. Perhaps the small segment vibrated more,
disintegrating the rubber seals?
The first 260 hours of flying my rotary bird was with stock 3-piece
seals, and I never saw any chatter marks. The last 250 hours has been
flown with 2 piece seals and now I have chatter marks .
I now have Tracy's 2 piece apex seals and I wonder how they will
perform, it appears that the heavier weight of the 2 piece seals puts
the resonant frequency in the cruising range of 6000RPM?

Chuck Dunlap
RV6 13B

----------------------------------------------------------------

Couple of things Chuck. Are you mixing two cycle oil with the fuel?
If so what kind of oil? What brand of seals did you have in there?

Recently I have seen some chatter marks on Dave Leonard's engine too.
I asked Dave what the brand of the apex seals were and he did not tell me.
He kind of changed the subject or he did not know. Years have gone by and
we have not heard of or seen chatter marks. Lately several companies are
claiming they are making their own apex seals.


Seal chatter has a lot to do with the exact material they are made from.
Mazda uses a special cast iron alloy that is heated with
a laser and chilled in liquid nitrogen. They would not do this unless it
was necessary as it is costly. I'll send some more data on this shortly.

Mazda has spent millions on seal research so I would not buy anything
other than Mazda apex seals. Mazda  have a new two piece seal that will
fit in your engine. Many kinds of steel alloys have been
tried and they are known not to work including tool steel.

Silicon nitride ceramic apex seals by Ianettie are known to
work well as the density is much less than steel so too is the weight
This raises the resonant frequency. They are diamond ground to
super smoothness to cut the friction which is also a factor
in apex seal chatter.

Apex seal chatter also has a lot to do with the spring
pressure. The right springs must be used and tailored to the
material the apex seal is made from.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.