Subject: Traction drive with spur gear reduction
From: Rotary Engine
Date: 3/16/2006, 9:15 AM
To: AAme




Paul,

Come on you are a genius.  There are more than one way to thread a shaft and
skin a clutch:)   Here is the what I had in mind.

I am planning on picking up the guts from another larger traction drive from
ROTREX.  They use it with their C38- series and it can take more torque and
has a thicker  input shaft.  The transfer efficiency is greater as well.
98.4%. but  7.5 :1 ratio. Still within usable limits with a turbine with
maximum rpm of 85K.  More like a flywheel then. CVT has a clutch built in.


Below is my second feeble attempt with Rhino.  I've yet to figure out how to
curve a pipe so I can bring the p-port pipes over to the intercooler.

I will use two double pass radiators with the internal core of 1.25t"X12"W
x24"L  and mount them at an angle on the lower side and have the oil cooler
underneath.  I am making a custom cowl anyway. There is enough space to make
some nice K&W ducting to them.  Cowls become closer to a oval shape which is
the shape it tapers to in back.

Lots of air entrances though.  Probably need a smiling mouth. Air goes to
three lower heat exchangers, and out through louvers or if I have room and
it is non restrictive, ducted backwards to a lower pressure area where the
cowl tapers into the cantilever support.   The starboard side where the
Rotrex supercharger side needs a side mounted filtered rammed air scoop.

The starboard intercooler and and port side exhaust shrouding for cabin
heater use can get by with smaller holes behind the prop area.   A large
truncated cone filter resides inside the round duct to the supercharger and
two circular U-clamps on the duct flanges provides the quick release to pull
that section out to get at the spark plugs.

The engine mount is..... errr..  ahhh....sort of a combination between bed
and rear mount.... Well I better draw it first.  You'll like it:)



<<<<<<<<<<<<<<<<<<<<<<FOR   SALE>>>>>>>>>>>>>>

The C&R custom made radiator I bought from Brian Trubee is for sale as it is
too small for my needs.  It is still brand new back in the original box.
$270 plus shipping from the West Coast.  Available next month in California.

The size:  Inner radiator core is 17.5" x  24" with two 2"X2" wide tanks on
each end.  OD is 19"X 27.5"  It is a double pass with two 1" NPT female
threaded bosses welded to one end.


Cheers

Doug Fir




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.