Subject: OIl pan 11-05 dimensions
From: Rotary Engine
Date: 3/22/2006, 8:26 AM
To: AAme


Paul-

Two holes in this drawing are not dimensioned on the plan.  Are they
1.5" like the other smaller hole?  Getting this fabbed on Thursday  so I
can install it on Saturday.  Also got all the fiberglass supplies &  now
have a plan ... woo hoo, progress at last...

Mark Supinski

Ops don't do it . I had problems with that one let me do another.
Here it is. The top dimensions and thicknesses are exactly the same
but there is more room for a stock oil pick up tube and screen.

The two holes unmarked are not critical. Anything between 1.5 and 2 is
fine. They are oil drain back holes.
-- 
Paul Lamar ...No rotor no motor.


Paul, if can you add to this drawing the option for the strut bracket
and also the forward flat area for the S-beam, the drawing would
satisfy all situations. The oil pickup has a fairly large diameter
which might still touch the bottom where it slopes upward.  I had
this problem with the pan I built.  I have been thinking about
building a new pan and relocating the pick up so that it is at the
back in the deepest part of the pan.  This would insure that the pick
up remains  covered in steep climbs. It may be that a straight (easy
to make) pick up will work in the rear location.     Regards,  Jerry

---------------------------------------------------

This one should clear the stock pickup.
I hate to change anything in the rotary unless absolutely necessary.
Seems like any time we do that unforeseen problems occur.

Climb angles may appear steep but I suspect they rarely exceed 20 degrees
unless you are doing aerobatics and then you need a dry sump system.

When you have five quarts in the engine this sump should be close to full.
The RX8 pan would probably be full and then some up in the block.

I think what you are asking for is the dimensions on the last oil pan we did
for the beam under the pan.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.