Paul-

Two holes in this drawing are not dimensioned on the plan.  Are they
1.5" like the other smaller hole?  Getting this fabbed on Thursday so I
can install it on Saturday.  Also got all the fiberglass supplies & now
have a plan ... woo hoo, progress at last...

Mark Supinski

Ops don't do it . I had problems with that one let me do another.
Here it is. The top dimensions and thicknesses are exactly the same
but there is more room for a stock oil pick up tube and screen.

The two holes unmarked are not critical. Anything between 1.5 and 2 is
fine. They are oil drain back holes.
--

Paul,
Does this pan have clearances for the schertz beam under the engine?


--
Blake C. Lewis

No it does not. Mark has a rare beam and a rare rear motor mount.

Keep reading. The one you are looking for is coming.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.