Paul,
We have solid works too. Master Cam X, and Master Cam 9.
We do not have edm, and do not expect you to walk away from a shop who
have taken good care of you. But I want you to know that we have two
Haas vertical mills which are bigger than the one you sent a JPG of.
I do wish your project the best of luck, while I am confident you have a
wealth of knowledge and experience, so luck may not be so important. I
look forward to reading more.
Respectfully,
Jeffrey Klein
Thanks Jeff.
That EDM comes in handy when you are cutting hard materials.
Our gear boxes are tiny :)
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.