Subject: 13B Possible belt PSRU
From: Rotary Engine
Date: 3/30/2006, 12:16 AM
To: AAme



Hi Paul & all,

Another question if you don't mind please. Does anyone know of a similar belt PSRU installation on a
13B? (I know the 13B's output is much higher than the engine's in the photo) And if so, would you
regard such an installation safe for use. Just by looking at it, it seems to be both light weight
and simple to fabricate. Plus, on an amphip, it would allow the engine to be mounted lower with the
prop still clearing the hull which would be good for overall cg.

Regards,

Hennie

I think that is a great idea. Here is a an old drawing on the idea I did
back before Rhino. You would also have higher prop efficiency and lower
overall drag due to better pylon streamlining.

Contact Ken Welter. He has hundreds of hours with a belt PSRU of his
own manufacture.

http://homepage.mac.com/rotarycoot/

BTW Ken, does your girlfriend have a rotor tattooed on her stomach? :)
--
Paul Lamar ...No rotor no motor.


Hi Paul,

Thank you for the information. Now I know I'm on the right track, at least for my project that is.

I have another question dealing with weight and simplicity please. I read the following by Tracy:

"I found the use of short (about 1 and a half inches), straight intake manifolds  to be very interesting.  Up until this point, the engine sellers have all stressed the importance of long intake runners and tuning for good horsepower.  I always thought this was an attempt to convince builders that it took  super smart engineers and hundreds of hours of dyno testing to arrive at a good intake system.  In other words, they were saying, don't try this at home, kids.   I accept their use of short, straight intake manifolds as proof that the ones on my 13B rotary were not such a bad idea  after all.

  As further evidence that this does work, take a look at motorcycles.  These are some of the highest power per cubic inch engines in the world and the carburetors are coupled directly to the intake ports on the heads."

I will enquire more detail from Tracy over at his forumn. I just want to know your opinion on this as it will really simplify things a lot for me. Also, with the carbs mounted almost against the block, do you think that carb heat would still be required?

Once again thank you for your time and patience.

Hennie

Short manifolds do indeed work for max power. Especially if you are using small pipes
like Tracy is using. Short pipes  cut the skin friction drag of the air
flowing through long small pipes. However they don't give the best BSFC at cruise
5000 to 6000 RPM because they are not taking advantage of the organ pipe effect.
Ram charging Dodge called it. IMHO something around 15 to 20 inches with a 2" inch
P-pipe works great and gives good BSFC in the bargain.

Tracy has been around the block on these manifolds. A couple of years ago
he and Ed Anderson were hot for dynamic chambers. :) He will soon figure out Mazda knew
what they were doing on the Lemans engine. :) Mazda had a race fuel limit at Lemans
so a good BSFC was critical.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.