Hi Paul & all,
"Subject: More comments from Paul Lamar
As back ground info on the rotary. The bare engine block weighs about
190 pounds with cast iron end housings. About 140 pounds with aluminum end housings."
Anyone flying with these aluminum end housings? Any links to more info?
(Please excuse my ignorance if these are well known or previously discussed items)
Thanks,
Hennie
---------------------------------------------------------
Never a problem on previously discussed items.
That is why we are here.
Not that I know of now. Allan Tolle probably flew an Everett Hatch
all aluminum engine ten years ago or so.
They are rather expensive. At about $1200 to $1500 USD
from Racing Beat. The rear and two rotor intermediate housings
in this 3 rotor engine picture are aluminum.
There is some question about the wear surface process and durability.
Racing Beat would not tell me what the wear surface process was so I doubt it
was detonation gun coated. If I were building all aluminum end housings
I would brag about using proven, expensive detonation gun coatings.
IMHO the ONLY reliable way of doing an all aluminum end housing IMHO.
If the wear surface does not hold up on these Racing Beat aluminum
end housing you could always have them detonation gun re coated
with silicon carbide and diamond reground.
Richard Sohn is also developing a two piece end housing with
cast iron wear surface.
<unicorn@gdsys.net>
Paul Lamar ...No rotor no motor.
-------------------------------
Thank you for the info Paul. I'm trying to find all the info I can on reducing
the installed weight of a 13B as I really want to use it on an amphibian project.
Hennie
---------------------------------------------------------
Your welcome Hennie. Please send some pictures of your project. We are always
interested in rotary powered airplanes.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.