Subject: 13B Possible belt PSRU
From: Rotary Engine
Date: 3/30/2006, 12:00 PM
To: AAme



I can not endorse a cog belt drive PSRU which has unsupported outer
races.  One should have bearing supports on both sides of the cog
belt! We have discussed the large P-forces imposed by rapid angular
changes to the airframe( as per flying through turbulent air).
 I hesitate to mention our pumping of unknown stresses through the
block.  I urge everyone to use engine mount locations to conduct the
stresses into the airframe via the engine mount, not through the block.

John Andrich

Neither can I John. But most PSRU designs do exactly that.
Back in the early days we did a PSRU plate with motor mounts
on it but nobody wanted to use it because Tracy did not like it
and said the warrantee on his PSRU would be void. Pissed me off :)
Jerry hey did full scale deflection test on it in an attempt to convince
Tracy it was OK.

Also see.

http://www.rotaryeng.net/beltpsr4.gif

I never really liked the PSRU on that small German Wankel engine.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.