>Paul,

I am in the final phase of my house building, and have done very little on
the side housing for a while. I was able to finish the casting pattern, and
am ready to find a foundry.

I also did some improvement on my mill, like 3-axis DRO, and am working on
4-axis stepper drive. The "A" axis is the turn table.
The house work should be done in a couple of month, when I plan to be back
at the one rotor full steam.
You mentioned a foundry you are working with, but I somehow lost name and
anything else you mentioned. If you could please let me know again.

Thanks

Richard Sohn
N-2071U


American International Engineering & Manufacturing
860 Arroyo St.
San Fernando, CA 91340
Phone: 818-365-8000
Fax: 818-365-8819
http://www.aiem.com/-

Paul Lamar ...No rotor no motor.

Thanks Paul!!

Richard Sohn
N-2071U


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.