The box is in the NC machine shop.
Should be done when I get back from Sun & Fun.
Next step is build up a turbo II engine and test it on the
dyno.

Here are a few 3D's of the traction drive parts and final
drive.

I may give an AIAA paper on the subject on May 13 in Anaheim Ca.

Paul Lamar ...No rotor no motor.

Paul,
Your forum at Sun N Fun was probably the most important talk given at
the show!  I noticed something during your presentation that I forgot to
mention afterward.  The FEA analysis of the friction ring would suggest
that the outer corner of  the ring should be rounded.  I would guess
that a radius in the range of  1/16" would do.  Fatigue cracks may
develop pretty quickly without the rounding.

Aubrey

Thanks for the complement. I was quite happy with myself.
I too thought I did a good job for a change :)

Good point Aubrey.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.