Subject: Hollow Shaft Cog Belt Drive (HSCBD)]
From: Rotary Engine
Date: 4/12/2006, 8:39 PM
To: AAme


Paul,

With all the recent posts re a cog belt drive I'm hesitant to post this.

Back on 8/26/03 in a post on the hollow shaft PSRU you wrote;
<>
"I think I know what you are thinking Ken. Yes... a large hollow thin
wall shaft
with needle bearings would cut the weight of your belt drive. When one
thinks about
it...it does not make a lot of sense to go from a 12 inch pulley down to
a 2 inch
solid steel shaft and then back out to a six inch prop bolt circle."

That stuck in my mind and when I started thinking about a way to drive a
pusher
prop for a Light Sport Aircraft from a single rotor engine I decided to
make a crude
mockup of a possible implementation.

The attached JPG's show what might be considered. The tube is only 4" ID
because
I had some scrap PVC that size. As you can see the idea is to mount the
outer shell
to the front and rear end plates. The entire unit would cam over for
belt tensioning.
There is some doubt in my mind whether the thermal expansions of the
engine block
and the drive length can be matched or if the front (auto) end needs to
be a slip fit
of some sort. The spread between the mounting plates is 6". Plates would
be 3/8"
4130. Obviously there is a great deal of detail missing.

So guys, I'd like you all to take pot shots at this. Is it worth
pursuing or just dumb?

Fred O.

Looks OK to me Fred so far.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.