Subject: Hollow Shaft Cog Belt Drive (HSCBD)
From: Rotary Engine
Date: 4/13/2006, 4:49 AM
To: AAme



   So guys, I'd like you all to take pot shots at this. Is it worth
   pursuing or just dumb?

   Fred O.

   Looks OK to me Fred so far.

   --
   Paul Lamar ...No rotor no motor

Looks OK Fred. At least all the torque that the shaft takes has a short
path back into the engine.
BTW The reason for the multiple belt arrangement on the Eggenfellner
redrive is to provide opposing belt pulling forces. At least when all
the belts are working you should get nearly zero around the center
shaft. The prop flange can have whatever number of holes you want, as
the flange comes off the center shaft and could be set up SAE#2 or what
ever you want.

Fred, be sure to watch your bearing speed. I'm sure you can get some
that will work but be sure they are rated for the higher speed caused by
a larger shaft diameter. You didn't mention if the unit would be greased
or pressure fed for lube.
Bill Jepson

-------------------------------------------------

True in theory Bill but the top shaft is supposed to
provide that support. For every action there is a reaction.
It is the long cantilevered top shaft on the Eggenfellner
that has the cyclical fatigue problem even if no belts
break. Not only must it deal with its own developed belt tension
it must deal with some of the lower belt's tensions.

Good point on the bearing speed.


Fred, The major problem
will be the one rotor torque pulse effect on the cog belt.
You should think about a torque pulse isolator.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.