Subject: Hollow Shaft Cog Belt Drive (HSCBD)
From: Rotary Engine
Date: 4/14/2006, 9:39 AM
To: AAme



    True in theory Bill but the top shaft is supposed to
    provide that support. For every action there is a reaction.
    It is the long cantilevered top shaft on the Eggenfellner
    that has the cyclical fatigue problem even if no belts
    break. Not only must it deal with its own developed belt tension
    it must deal with some of the lower belt's tensions.

    Good point on the bearing speed.


    Fred, The major problem
    will be the one rotor torque pulse effect on the cog belt.
    You should think about a torque pulse isolator.

    Paul Lamar ...No rotor no motor.

Paul, Very good point on the torque pulse effect. I believe the major
car manufacturers use the ratchet spring tensioner to help that problem.
This results in a VERY tight belt though. Don't forget to add that
tension load (static) to bearing calcs.
Bill


 Yes torque pulse when the spark plug fires puts the same load on
the belt as a two rotor and then you have the bad torsional vibration
of the single rotor so I would run an 85 mm belt which is the same as
I use on my coot, Atkins wanted me to build him redrives with 50 mm
belts for single rotors and I told him I would not.
 No you do not want a belt tensioner as you want to run the belt
loose, about a 1/4 inch free slap in it, the reason is that the
centrifugal force slings the belt outward as it wants to run in a
perfect circle an when the plug fires and the belt gets that power
pulse it has to straiten out that bulge in the belt so what it gives
you is a built in torsional damper.
 If I tighten up my  belt tight it will develop a vibration, also if
its to loose it will vibrate also so there is a sweet spot you need
to find.
Ken Welter


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.